Suburb guide · 2210
Can I build a duplex or granny flat in Peakhurst Heights?
Peakhurst Heights sits in Georges River Council's area under Georges River Local Environmental Plan 2021. We ran 24 real Peakhurst Heights addresses through the checker: the typical block is 579 m² with 16.2 m of frontage, 20 of the 24 could add a granny flat, and 1 could carry two separate homes today.
Thinking of building or selling in Peakhurst Heights?
Tell us what you have in mind and we'll read your block and come back to you within a day. Free, no obligation.
The typical Peakhurst Heights block
The middle block of the 24 we checked is 579 m² with 16.2 m of street frontage. The smallest was 397 m² and the largest 672 m². Zones in the sample: R2 (24).
The 24 blocks we checked, by land size.
What homes sell for in postcode 2210
Median sale prices for the whole of postcode 2210, January to March 2026. These cover every suburb sharing the postcode, not Peakhurst Heights alone, and they are not a value for any one block.
- Houses: $1.65m (45 sales)
- Units and apartments: $813k (42 sales)
Source: NSW Government Rent and Sales Report (Department of Communities and Justice), sales tables by postcode, NSW Government. Updated each quarter.
A granny flat
20 of the 24 blocks we checked could take one. Georges River LEP cl 5.4(9) — the greater of 60 m² or 10% of the house’s total floor area, parking excluded. Separately, the state Housing SEPP allows a granny flat of up to 60 m² through the ten-day complying-development route on a lot of 450 m² or more with a 12 m frontage, where the land is not flood, bushfire or heritage constrained.
Dual occupancy (duplex) rules in Peakhurst Heights
1 of the 24 blocks we checked could carry two or more separate homes today.
Under Georges River Local Environmental Plan 2021 a dual occupancy needs 650 m² and 15 m of frontage.
Of the 24 ordinary R2 blocks in our sample sitting outside the Low and Mid-Rise area — where that minimum is the only test that applies — 19 had the frontage and 3 had the land. 2 had both.
So in Peakhurst Heights it is the area that stops a second home more often than the frontage. A block short on land cannot be stretched, but two neighbouring blocks together clear it easily — which is why duplex sites here tend to be assembled in pairs rather than found.
Low and Mid-Rise
None of the 24 blocks we checked fell inside the state Low and Mid-Rise area, so in this part of Peakhurst Heights the LEP minimums are what count. The boundary is a walking distance from a listed centre, so it can cut through a suburb — the checker reads which side of it your own address sits on.
What else turned up
5 of 24 were on bushfire-prone land. Any of those takes a block out of the fast-track routes and into a full DA, so it changes the answer more than the lot size does.
How we got these numbers
We took 24 real Peakhurst Heights street addresses from the NSW geocoder and ran every one through the same engine this site runs for you, reading the planning controls live. Nothing here is modelled or estimated.
It is a sample, not a census. The addresses are a spread across what the geocoder returns, so treat these as "of the 24 blocks we checked" rather than a figure for every block in Peakhurst Heights. Your own block is the only one that answers for itself — that is what the box on the right is for.
Enter the address — lot, frontage, zone, constraints and what it can carry.