Suburb guide · 2212
Can I build a duplex or granny flat in Revesby?
Revesby sits in City of Canterbury Bankstown's area under Canterbury-Bankstown Local Environmental Plan 2023. We ran 25 real Revesby addresses through the checker: the typical block is 675 m² with 15.2 m of frontage, 19 of the 25 could add a granny flat, and 13 could carry two separate homes today.
Thinking of building or selling in Revesby?
Tell us what you have in mind and we'll read your block and come back to you within a day. Free, no obligation.
The typical Revesby block
The middle block of the 25 we checked is 675 m² with 15.2 m of street frontage. The smallest was 129 m² and the largest 4,048 m². Zones in the sample: R2 (18), E4 (3), E1 (3), R3 (1).
The 25 blocks we checked, by land size.
What homes sell for in postcode 2212
Median sale prices for the whole of postcode 2212, January to March 2026. These cover every suburb sharing the postcode, not Revesby alone, and they are not a value for any one block.
- Houses: $1.69m (33 sales)
- Units and apartments: not published (10 or fewer sales this quarter)
Source: NSW Government Rent and Sales Report (Department of Communities and Justice), sales tables by postcode, NSW Government. Updated each quarter.
A granny flat
19 of the 25 blocks we checked could take one. Canterbury-Bankstown LEP cl 5.4(9) — the greater of 60 m² or 10% of the house’s total floor area, parking excluded. Separately, the state Housing SEPP allows a granny flat of up to 60 m² through the ten-day complying-development route on a lot of 450 m² or more with a 12 m frontage, where the land is not flood, bushfire or heritage constrained.
Dual occupancy (duplex) rules in Revesby
13 of the 25 blocks we checked could carry two or more separate homes today.
Under Canterbury-Bankstown Local Environmental Plan 2023 a dual occupancy needs 500 m² and 15 m of frontage.
Of the 18 ordinary R2 blocks in our sample sitting outside the Low and Mid-Rise area — where that minimum is the only test that applies — 12 had the frontage and 17 had the land. 12 had both.
So in Revesby it is the frontage that does the stopping — the land is there on plenty of blocks, but they are narrow and deep. Width is the harder of the two to solve.
Low and Mid-Rise
None of the 25 blocks we checked fell inside the state Low and Mid-Rise area, so in this part of Revesby the LEP minimums are what count. The boundary is a walking distance from a listed centre, so it can cut through a suburb — the checker reads which side of it your own address sits on.
What else turned up
1 of 25 were on bushfire-prone land. Any of those takes a block out of the fast-track routes and into a full DA, so it changes the answer more than the lot size does.
How we got these numbers
We took 25 real Revesby street addresses from the NSW geocoder and ran every one through the same engine this site runs for you, reading the planning controls live. Nothing here is modelled or estimated.
It is a sample, not a census. The addresses are a spread across what the geocoder returns, so treat these as "of the 25 blocks we checked" rather than a figure for every block in Revesby. Your own block is the only one that answers for itself — that is what the box on the right is for.
Enter the address — lot, frontage, zone, constraints and what it can carry.