Suburb guide · 2756
Can I build a duplex or granny flat in Sackville North?
Most of Sackville North is land this tool does not answer for. 25 of the 25 blocks we checked sit in rural, conservation, industrial or special-purpose zones rather than a residential one, and Block Checker covers residential zones only. The counts below are what it could assess — they are not a finding that nothing can be built. For land like this, a planner reads the LEP for the zone directly.
Sackville North sits in The Hills Shire Council's area under The Hills Local Environmental Plan 2019. We ran 25 real Sackville North addresses through the checker: the typical block is 9,032 m² with 130.7 m of frontage. Most of them are not residential land, so see the note below before reading the counts.
Thinking of building or selling in Sackville North?
Tell us what you have in mind and we'll read your block and come back to you within a day. Free, no obligation.
The typical Sackville North block
The middle block of the 25 we checked is 9,032 m² with 130.7 m of street frontage. The smallest was 810 m² and the largest 100,951 m². Zones in the sample: RU2 (25).
The 25 blocks we checked, by land size.
What homes sell for in postcode 2756
Median sale prices for the whole of postcode 2756, January to March 2026. These cover every suburb sharing the postcode, not Sackville North alone, and they are not a value for any one block.
- Houses: $1.18m (93 sales)
- Units and apartments: $865k (11 to 30 sales, a small sample)
Source: NSW Government Rent and Sales Report (Department of Communities and Justice), sales tables by postcode, NSW Government. Updated each quarter.
A granny flat
0 of the 25 blocks we checked could take one. The Hills LEP cl 5.4(9) — the greater of 60 m² or 20% of the house’s total floor area, parking excluded. Separately, the state Housing SEPP allows a granny flat of up to 60 m² through the ten-day complying-development route on a lot of 450 m² or more with a 12 m frontage, where the land is not flood, bushfire or heritage constrained.
Dual occupancy (duplex) rules in Sackville North
0 of the 25 blocks we checked could carry two or more separate homes today.
Under The Hills Local Environmental Plan 2019 a dual occupancy needs 600 m² — this LEP sets no frontage minimum, so Council's DCP governs width.
Low and Mid-Rise
None of the 25 blocks we checked fell inside the state Low and Mid-Rise area, so in this part of Sackville North the LEP minimums are what count. The boundary is a walking distance from a listed centre, so it can cut through a suburb — the checker reads which side of it your own address sits on.
What else turned up
25 of 25 were on bushfire-prone land; 1 of 25 carried a heritage listing or conservation area. Any of those takes a block out of the fast-track routes and into a full DA, so it changes the answer more than the lot size does.
How we got these numbers
We took 25 real Sackville North street addresses from the NSW geocoder and ran every one through the same engine this site runs for you, reading the planning controls live. Nothing here is modelled or estimated.
It is a sample, not a census. The addresses are a spread across what the geocoder returns, so treat these as "of the 25 blocks we checked" rather than a figure for every block in Sackville North. Your own block is the only one that answers for itself — that is what the box on the right is for.
Enter the address — lot, frontage, zone, constraints and what it can carry.