Suburb guide · 2571
Can I build a duplex or granny flat in Wilton?
Wilton sits in Wollondilly Shire Council's area under Wollondilly Local Environmental Plan 2011. We ran 24 real Wilton addresses through the checker: the typical block is 1,014 m² with 20.2 m of frontage, 11 of the 24 could add a granny flat, and 8 could carry two separate homes today.
Thinking of building or selling in Wilton?
Tell us what you have in mind and we'll read your block and come back to you within a day. Free, no obligation.
The typical Wilton block
The middle block of the 24 we checked is 1,014 m² with 20.2 m of street frontage. The smallest was 370 m² and the largest 158,407 m². Zones in the sample: R2 (13), MU1 (6), RU2 (5).
The 24 blocks we checked, by land size.
What homes sell for in postcode 2571
Median sale prices for the whole of postcode 2571, January to March 2026. These cover every suburb sharing the postcode, not Wilton alone, and they are not a value for any one block.
- Houses: $1.33m (68 sales)
- Units and apartments: not published (10 or fewer sales this quarter)
Source: NSW Government Rent and Sales Report (Department of Communities and Justice), sales tables by postcode, NSW Government. Updated each quarter.
A granny flat
11 of the 24 blocks we checked could take one. Wollondilly LEP cl 5.4(9) — the greater of 60 m² or 25% of the house’s total floor area, parking excluded. Separately, the state Housing SEPP allows a granny flat of up to 60 m² through the ten-day complying-development route on a lot of 450 m² or more with a 12 m frontage, where the land is not flood, bushfire or heritage constrained.
Dual occupancy (duplex) rules in Wilton
8 of the 24 blocks we checked could carry two or more separate homes today.
Under Wollondilly Local Environmental Plan 2011 a dual occupancy needs 800 m² — this LEP sets no frontage minimum, so Council's DCP governs width.
Of the 13 ordinary R2 blocks in our sample sitting outside the Low and Mid-Rise area, 11 had the 800 m². There is no LEP frontage test to pass here, but Council's DCP still judges width, setbacks and private open space, so clearing the area alone does not settle it.
Low and Mid-Rise
None of the 24 blocks we checked fell inside the state Low and Mid-Rise area, so in this part of Wilton the LEP minimums are what count. The boundary is a walking distance from a listed centre, so it can cut through a suburb — the checker reads which side of it your own address sits on.
What else turned up
13 of 24 were on bushfire-prone land. Any of those takes a block out of the fast-track routes and into a full DA, so it changes the answer more than the lot size does.
How we got these numbers
We took 24 real Wilton street addresses from the NSW geocoder and ran every one through the same engine this site runs for you, reading the planning controls live. Nothing here is modelled or estimated.
It is a sample, not a census. The addresses are a spread across what the geocoder returns, so treat these as "of the 24 blocks we checked" rather than a figure for every block in Wilton. Your own block is the only one that answers for itself — that is what the box on the right is for.
Enter the address — lot, frontage, zone, constraints and what it can carry.